Most cold rooms that struggle are not short of refrigeration capacity. They are losing cold air through a door, fighting a blocked evaporator or running a defrost cycle that never finishes properly.
This checklist is for Milnerton restaurants, butchers, delis and small food businesses that want a cold room to hold temperature without working itself to death.
Doors and seals
Check the gasket all the way around with a torch at night or a sheet of paper: if it slides out easily, cold air is escaping. Look for torn corners, hardened rubber and a door that drops or drags on the frame.
Door heaters and strip curtains are not decoration. A failed heater causes condensation and ice at the frame; missing strips let warm air in every time someone walks through.
Airflow inside the room
Stock stacked above or in front of the evaporator blocks the air path. The room then has warm pockets and the thermostat reads a misleading average. Keep a clear gap around the evaporator and do not pack product against the walls.
Overloading a room with warm product at the end of a delivery pushes the unit hard for hours. Split deliveries or pre-chill where you can.
Defrost and drainage
The defrost cycle melts frost off the evaporator and sends the water to a drain. If the drain is blocked or the trap is dry, water ends up on the floor or refreezes. If the heater or termination sensor fails, frost builds until airflow stops.
Watch for ice on the floor near the evaporator, water pooling outside the room, or the unit running a long defrost during busy periods. All are worth investigating.
Condensing unit and surroundings
The outdoor unit needs airflow and shade. A unit boxed in, covered in dust or sitting in a hot, enclosed yard cannot reject heat, and everything inside the room suffers as a result. Clean the condenser and keep the area clear.
Coastal corrosion applies here too: check the coil, fan guard and mounting for rust, and make sure the electrical enclosure is sealed.
Records that prove it is working
Log the room temperature at least daily, and more often during hot weather or heavy deliveries. A written record shows a trend before a failure, and it is the first thing anyone asks for if stock is lost.
Keep service records per room, including what was checked and any parts replaced. It makes budgeting and any later insurance conversation much simpler.
This guide is general information for Milnerton conditions, not a diagnosis of your equipment. If something is not working as described, have it checked before carrying on.